Sunday, February 24, 2019

Step By Step: How to Change A Tyre

It is important to know exactly how to change a tyre in case you end up into a messy situation on the side of the highway. Some of us have people to call in these cases but there are occasions where you might be far out and help could take some time to arrive. Here is an easy step-by-step tutorial on how to change your tyres.











  1. Firstly, make sure that you stop on the side of the road where it is safe and you have enough space to change the tyre. Always be aware of the oncoming traffic where you are changing the tyre.










  2. Making sure that you have all the necessary tools to do this job is an important factor. You will need a tyre iron, a jack, a spare tyre that is properly inflated and fit for the purpose, as well as the manual for the car. This manual will give you the necessary instructions on how to change the tyre if there are specific features your car may have.










  3. Make sure that you have the handbrake activated before you start with the wheel changing process. It is also important to place an object behind the opposite wheel in case the car starts to roll backwards.










  4. On most cars, there are indentations under the car that make for a stable place to place the car jack. You can see where these indentations are by means of small markings along the side of the car. The side of the car has to be at least twenty centimetres off the ground so that you can easily change the part.










  5. You will need to remove the hubcap so that you can reach the tyre. The hubcap has been clipped on and can be removed by wedging the flat part of the tyre iron into the crevice of the cap. The hubcap is the part of the tyre that protects the lug nuts beneath.










  6. Loosen the lug nuts using the correct side of the iron. Some cars have special adaptors that fit onto the nuts. You won't need to completely remove the lug nuts as of yet. You can remove them as soon as you have taken the tyre off of the wheel. The tyre should simply click out of place and be easy to remove.










  7. Fit the spare tyre to the wheel piece. The bolts have to line up with the holes. Place the lug nuts onto the bolts and start tightening it equally by hand. You can then use the iron to tighten the nuts properly without having wasted too much energy. Do not over fasten as it could break.










  8. You can then place the hubcap back onto the face and lower the car. The spare tyre should only be used for emergency moments. You will notice that they are narrower than a regular tyre.










Now you can drive safely to a fitment centre. As soon as you get there you should get the tyre replaced.